Short Description (20 words or less): *

Full Description: *

TEMPORARY: 'C' CORE PULL POSITION IS HIGHER THAN THE RUNNER SYSTEM BY 5.72MM. THIS ALLOWS ALUMINUM TO SPILL OUT OF THE MOLD AT ROLL OVER. REMOVE 7MM OF STOCK ON THE BOTTOM SIDE OF THE CORE PULL. THIS WILL RAISE THE ELEVATION OF THE POUR SPOUT HIGHER THAN THE RUNNER SYSTEM, PREVENTING ALUMINUM FROM POURING OUT AT THE ROLL OVER. THIS WILL BE DONE IN SMCO ON C#5. WHEN THIS GOES PERMANENT, PUT THIS FEATURE IN THE CORE STICK.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	GEN 4 C-CORE INSERT CORE PULL.ppt	PICTURES	Waters, Russ (hzskw3)	1/31/2006 9:03:31 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12571048	Prod	Saginaw	Waters, Russ	Complete - Approved

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12577461	Prod	Saginaw	Waters, Russ	Complete - Approved