Short Description (20 words or less): *

Full Description: *

Make the following corrections or clarifications to the Slab Corebox cad data 1) Remove clearance for tamp plate bolt on upper insert dwg #26155 see attached picture ‘tpbolt’ 2) Correct note on lower ejector plate dwg #25575 that calls for length of adjustable ejector tip to be 2.5” should be 1.25” for ach39553 3) Add supplier information for Riser seal to gpt28000 and gpt280001 or lower insert dwg #ach38700 because they are no longer supplied by GM – Supplier information is Binkelman Corp (989) 755-6330 4) Add specifications for installation of super vents on dwg # 18394 5) Revise note on upper insert dwg #26155 and lower insert dwg #ach38700 to read that the preferred method of machining validation hole covers is cap screw

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	tpbolt.ppt	Relief for Tamp pin bolt	Adcock, Jill (fzl662)	10/31/2006 2:55:22 PM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN III	Head	12562317	Prod	Saginaw	Adcock, Jill	Complete - Approved

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN III	Head	12559862	Prod	Saginaw	Adcock, Jill	Waived
GEN IV	Head	12560799	Prod	Saginaw	Adcock, Jill	Complete - Approved
GEN IV	Head	12600823	Prod	Saginaw	Sartor, Duane	Waived

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	11/1/2006 8:12:21 AM	Normal	Approved