Short Description (20 words or less): *

Full Description: *

Designs currently have (2) lift holes on each side of the frame. When only the top holes are used for pick up, the bottom of the tooling kicks out. This is because the pickup point is not at the CG of the tooling. This makes handling the tooling difficult & poses a safety concern. Therefore add an additional 1"-8 x 2.0" deep threaded hole at the CG on each side of both the fixed & tilt frames.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	ct03717.ppt	cg pickup holes	Laker, Andrew (fz5q01)	1/5/2007 3:25:50 PM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
Duramax V8	Block	97377917	Prod	Defiance	Singer, James	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Defiance	Meyer, Maurice	1/12/2007 12:32:46 PM	Normal	Approved