Short Description (20 words or less): *

Full Description: *

The tamping pins on the E-F waterjackets may be elongating the blow tube holes in the upper corebox due to the tamping pins being longer than the tamping plate locating pins. CHANGE: E-F jacket tamping plate. On the E-F tamping plate, install longer guide pins on the plate that will engage the tooling before the tamping pins do. ALSO, SHORTEN THE LOWER STOPS FOR THE ALIGNMENT PINS. See Attached This will prevent the tamping plate from wearing the blowtube holes elongated. The original tamp pin is used else where, therefore a new tamp pin will have to be developed.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	pps07-26.ppt	PICS	Waters, Russ (hzskw3)	3/1/2007 7:07:25 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12571048	Prod	Saginaw	Waters, Russ	Complete - Approved

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12577461	Prod	Saginaw	Waters, Russ	Complete - Approved

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	3/2/2007 2:14:41 PM	Normal	Approved