Short Description (20 words or less): *

Full Description: *

CHANGE: Increase the ejector rod diameter to the same diameter as the tip (.312) of the rod. This would allow the rod to be a one piece rod verses the current two piece rod. This was done under PPCR 06 143 has has worked. On the 048/461 water jacket, the ejector rods, over time, will vary in height causing an excess sand condition in the core. The end of the rod that screws to the shoe gets worn and will screw in further. This will cause the core not to seat properly in the slab. Less variation in ejector rod height

File Attachments:

File Name

Description

User Name

Upload Date

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12571048	Prod	Saginaw	Waters, Russ	Accepted

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12577461	Prod	Saginaw	Waters, Russ	Accepted

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw				Pending