Short Description (20 words or less): *

Full Description: *

With the directive to duplicate Massena's molding process as much as possible and within reason, Tom Miller has requested SMCO utilize Massena's thermal coupler wire specifications, see attachment. Tony Greanias has suggested a new thermal coupler connecter still located on the right hand side of the opposite operator side of the upper and lower frames using the current connector box, if at all possible, but the face plate may need to be revised to hold the new connectors, see attachment. Apparently SMCO's current thermal coupler set up was not functioning as expected. Also, the location of the thermal coupler on the back side of the upper and lower mold plates was determined by Tom Miller's review of each upper and lower mold plates.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	thermalcouplerwirespec.ppt	Thermal coupler wire spec	Noga, Gregg (fz01zg)	10/5/2007 7:53:18 AM
Delete	NewL850requiredThermalConnector.doc	Thrml. connector specs.	Noga, Gregg (fz01zg)	10/15/2007 9:10:32 AM
Delete	Thermalcouplerrelocations.ppt	Thrml. coupler locations	Noga, Gregg (fz01zg)	10/29/2007 7:18:14 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	10/29/2007 7:53:59 AM	Normal	Approved