Short Description (20 words or less): *

Full Description: *

The following was extracted form Steve Wolf's email: "Good Morning Gregg, There is a sharp corner going around the glue deck, below the shut-off areas. I looked at the assembly with the slides and that corner looks like a dead area. We would like to add a 2.3MM radius to this corner. I've attached a powerpoint to show you the corner. Steve Wolf-TEI." Good morning Steve, Apply a variable blend. 3.2 radius where possible and then down to a 2.3 radius then back up to a 3.2mm radius. Thanks, Gregg

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	CUprMoldplateRadiusfix.ppt	'C' upr mold plate radius fix	Noga, Gregg (fz01zg)	12/3/2007 7:16:19 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	12/3/2007 7:28:03 AM	Normal	Approved