Short Description (20 words or less): *

Full Description: *

Not long after the 'B' EQ#1, serials #1& #2, mold toolling arrived at SMCO on 01FE08, the Porcess Engineers had difficulty blowing an acceptable foam in the tie bar area. Jim Bujouves's past experience suggested to use a restrictor on the tie bar fill gun "AIR" yellow line as a test. It worked. In addition to the restrictor, adding a "T" connector between two specified fill guns also aided in the fill process. See the attached PowerPoint for more details. Note to the designer: the yellow "AIR" nylon lines are not typically modeled in the plumbing assembly, but for this particular instance, model in a "dummy" segment to give details on this small sub assembly.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	BFOAMFILLGUNRESTRICTOR.ppt	B tie bar fill gun restrictor	Noga, Gregg (fz01zg)	2/27/2008 7:13:39 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	2/27/2008 7:32:29 AM	Normal	Approved