Short Description (20 words or less): *

Full Description: *

The 3 bosses on the oil side of the D Slice are used to identify the RPO type of engine at the Engine plant. When the engine validation blocks were machined in Spring Hill the bosses did not fully machine up for the LE5 engines. Nemak had to add 1.5mm of process stock to insure the bosses clean up. Spring Hill has requested that SMCO add the same amount of stock the these bosses. Insure that there is enough finish stock to allow for a machined surface for all RPO.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	DSliceRPObosses.ppt	D Slice Add 1.5mm to 3 bosses	(dzsk2p)	6/2/2008 12:21:31 PM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	6/2/2008 12:39:51 PM	Urgent	Approved