Short Description (20 words or less): *

Full Description: *

Mis-runs on the balance shafts causing scrap. Add 1/4 inch diameter lightener pins to the Gating, D and C lower mold tools to the 6 center bolt bosses. The pins needs to be tapered. The pins must be a minimum distance of 5 mm below the fill gun. In the attached file are potential pin designs. The pins must be removable and reversible. The Gating pins should be 41.00 mm long, the C pins should be 55.00 mm long and the D pins should be 29.00 mm long. Fill with metal faster to get hotter metal to the defect area to eliminate the defect.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	Lightnerpin.ppt	G, D, C Lightner Pins	(dzsk2p)	6/24/2008 8:12:36 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	6/24/2008 8:23:05 AM	Urgent	Approved