Short Description (20 words or less): *

Full Description: *

In order to cube blocks at Nemak and premachine at G & S; the AA,BB, & CC locators will have to be machined to square the parts up. Currently the AA,BB, & CC locators are not being used at EAS. EAS uses a different locating system. The AA,BB, & CC locators were used on the Gen3 block. On one IBCC tool, add stock to the AA, BB, & CC locators in plastic. AA will have 4mm added, BB will have 2 mm added, and CC will have 1.7mm added. All the locators are located in the drawbacks. This will provide stock for the locators to be machined at Nemak. See attached for location. This should be done to one of the following Eq# 0,7, 8,9,or 11. This tool will be sampled and the castings will be followed as a group through CMI and then Nemak and G & S.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	GenIIIlocators.pptx	block locators	Appold, Brian (qz0qsm)	4/9/2009 2:20:01 PM
Delete	Gen4loc.pptx	Add stock to locators	Appold, Brian (qz0qsm)	4/14/2009 8:31:31 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12571048	Prod	Saginaw	Appold, Brian	Complete - Approved

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12577461	Prod	Saginaw	Appold, Brian	Waived

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	4/14/2009 2:22:42 PM	Normal	Approved