Short Description (20 words or less): *

Full Description: *

The B mold tooling is experiencing lack of fill in the water pump area due to the fill gun on the tie bar. The air flow from this fill gun blows beads out of the area causing fill problems in the cavities. Flow restrictors are being placed in the fill gun air hose to reduce the amount of air going into the mold cavity during fill. Two different size of ristrictor orifice diameters are being used for the two cavities (odd and even). Note: due to problems with the CT0 system, specifically Gregg Noga's user ID, Brian Appold's ID was used to write this request.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	B_RESTRICTOR.ppt	Restrictors added	Appold, Brian (qz0qsm)	8/4/2009 7:56:37 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	8/4/2009 12:35:20 PM	Normal	Approved