Short Description (20 words or less): *

Full Description: *

The 'A' foam is experiencing high level of scrap due to under fill in the intake side pan rail. One of the fill guns is being inactivated in order to eleminate the defect. A 300 piece run will be followed through Towanda Engine Plant with a SCR. Previously, a 10 piece sample study (SCR LF 09 017) was done to assess if this change had any impact on quality. Castings were followed through Magna Check and no adverse effect was detected. Remove fill gun and related plumbing, modify the upper mold plate, glastherm insulation, and cast coverplate, update process foams, and 'A to B' lower nest plate.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	LF09-325.pptx	Fill gun removal on 'A' tool	Noga, Gregg (fz01zg)	10/22/2009 10:42:16 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	10/26/2009 7:31:57 AM	Normal	Approved