Short Description (20 words or less): *

Full Description: *

There is approximately 2.5% scrap for the Head HPO feed holes being plugged due to core float. The minimum diameter of the pin should be 8.12mm at the parting upper to lower, the base of the pin at the mold plate will stay the same 9.1mm. Note: for the temporary PPCR LF09-340, one common pin geometry will work for all four locations, BUT, when change goes permanent, each of the four pins will require location engravings, to match respective mold plate location engravings, on the bottom of each pin (current pin part number’s are: apu09399, apu09439, apu09436, & apu09435). See attachments for reference.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	PPCRLF09-340.pptx	Ref temporary PPCR	Noga, Gregg (fz01zg)	1/27/2010 8:05:25 AM
Delete	OnecommonCpin03DE09.x_t	Pin geometry	Noga, Gregg (fz01zg)	1/27/2010 8:10:45 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
L850	Block	12612776	Prod	Saginaw	Noga, Gregg	Complete - Approved

Impacted Part Information:

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Bujouves, Jim	1/27/2010 8:27:29 AM	Normal	Approved