Short Description (20 words or less): *

Full Description: *

A change was made to the housing core glue vent pins a few years ago but this change took away the commonality of the pins. The models were changed but the pins were never changed. This is for the top two vent pins in the upper half of the H core that were overlooked and are now too short, on the model. On the H Housing Models; Restore the glue vent pins to the original dimension by adding back in the 1.5mm length so the pins will extend thru the core. The actual pins that the pattern shop makes are correct. This will keep the pins common and the G core pins will penetrate deeper than the H core pins but this is the same as we are currently running.See the attached.

File Attachments:

	File Name	Description	User Name	Upload Date
Delete	PS1044HSINGLEPIN.jpg	H vent pin too short	Appold, Brian (qz0qsm)	7/15/2010 10:40:23 AM

Submit Attachment:

File:

Description:

Add

Primary Part Information:   Select*

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12571048	Prod	Saginaw	Appold, Brian	Complete - Approved

Impacted Part Information:

Program	Part Type	Part #	Design Phase	Location	PTE	Status
GEN IV	Block	12577461	Prod	Saginaw	Appold, Brian	Waived

Location Information:

Location	TM	Approval Date	Priority	Status
Saginaw	Waters, Russ	7/15/2010 12:36:55 PM	Normal	Approved